Skip to main navigation Skip to search Skip to main content

SONIC simulation studies of power and particle exhaust, alongside impurity concentration, for JA DEMO tokamak design

Research output: Contribution to journal › Article › peer-review

Abstract

SONIC divertor code facilitates simultaneous calculations of seeding impurity (Ar) and fusion product (He) transport. D2 and Ar gases were injected at the outer midplane and upper location of the outer divertor, respectively. He exhausts in the detached divertor have been investigated for a reference series of JA DEMO with an increasing deuterium gas puff rate (50–200 Pa m3s−1) where Psep ∼ 250 MW and the radiation fraction is 0.8. The outer divertor heat load (qtotdiv) peaked in the attached region on the partially detached target, and the peak-qtotdiv was reduced to lower than 10 MW m−2 by increasing the D2 puff rate while maintaining a relatively low nesep (2 × 1019 – 2.5 × 1019m−3). Neutral and gas pressures in the divertor (PD0div, PD2div) were evaluated at exhaust slots of the dome and in the sub-divertor. The total pressure (PDtotdiv) in the D-puff scan was increased from 1.4 to 3 Pa at the outer exhaust slots, and the outer peak-qtotdiv was proportional to (PDtotdiv)−0.7. Plasma flow reversals with M// = 0.2 – 0.3 were generated near the detach–attach boundary above the outer divertor target. The influence of the flow reversal on the plasma and impurity transport was determined. Convective heat flux was reversed, which significantly affected the ion heat flux profile in the upstream SOL. The flow reversal reduced the impurity shielding and radiation loss in the outer divertor. Inner-enhanced in–out asymmetry of Ar concentration (cAr) was large near the separatrix in SOL, suggesting that Ar ions were transported from the inner SOL to the confined plasma. In the confined plasma (edge), both cAredge and cHeedge were reduced and poloidally uniform, where cAredge was reduced to the marginal level and cHeedge was below the design reference by system code assumption (cArmain: 0.6%, cHemain: 7%). Consequently, these SONIC results are generally consistent with the JA DEMO higher-κ design, and larger D-puff (and smaller ГAr,puff) operation is preferable for the large power exhaust in the divertor and the impurity control in the edge plasma.

Original languageEnglish
Article number086020
JournalNuclear Fusion
Volume66
Issue number8
DOIs
Publication statusPublished - 2026 Aug

Keywords

  • divertor simulation
  • He exhaust
  • impurity seeding
  • JA DEMO
  • power exhaust
  • SONIC

ASJC Scopus subject areas

  • Nuclear and High Energy Physics
  • Condensed Matter Physics

Fingerprint

Dive into the research topics of 'SONIC simulation studies of power and particle exhaust, alongside impurity concentration, for JA DEMO tokamak design'. Together they form a unique fingerprint.

Cite this